Purchase Marking TPAKs Today.
How To Refill The TPAK Re-Stack:
Step One:
Place the Re-Stack Rod into the hole in the TPAK Assembly Tray.
Step Two:
Turn the TPAK upside down and index the Re-Stack rod with the tip of the follower. Push the TPAK downward until the spring is fully compressed.
Step Three:
Insert the pin through the hole in the back of the TPAK and through the hole in the follower until it comes out the other side of the TPAK.
Pro Tip:
You may need to work the spring up and down a bit to get the follower hole lined up precisely to slot the pin through. Keep the pin perpendicular to the TPAK for easiest insertion.
Step Four:
Place the TPAK into the TPAK holder and replace the CO2 cylinder.
Step Five:
Remove one cap from the Re-Stack tube and replace it with the TPAK Adapter.
Step Six:
Carefully install the TPAK Adapter onto the top of the TPAK.
Step Seven:
Insert the Re-Stack Rod through the hole in the TPAK Adapter to push each round into the TPAK. Keep the rod perpendicular to reduce the risk of puncturing a round.
Complete:
The TPAK is now re-filled with fresh CO2 and 30 rounds. Be sure to keep the pin installed until you are ready to train so the rounds are not under the tension of the spring. Additional pins can be purchased to stage multiple TPAKs at once.